SUNNECKO 2PCS Kitchen Knives Set 6.5'' Chef 3.5'' Paring Knife Damascus Japanese VG10 Steel Blade Cut Cooking Knives G10 Handle

SUNNECKO 2PCS Kitchen Knives Set 6.5'' Chef 3.5'' Paring Knife Damascus Japanese VG10 Steel Blade Cut Cooking Knives G10 Handle
  • Продавецalatbantusex.us
  • Список ценUS $24.50piece
  • Продажная ценаUS $24.50piece
  • ДоставкаБесплатная доставка
  • Рейтинги4,8 (965)

Oписание продукта

[xlmodel]-[custom]-[28358]

[xlmodel]-[custom]-[8888]

description

Operation instructions:

Get ready

A. after cooling the tool, unscrew the nut.

B. insert the two knife legs of the blade respectively into the two knife seat.

Tight nut. Ensure that the blade and blade holder are in full contact. If the knife

The legs are not properly installed, the blade will not be heated.

C. power on

cutting

A. to avoid direct contact with the two knife block led to a short circuit.

B. the temperature control knob to the middle position, the blade on the cutting material, and then press the switch. Proposed to test the waste on the first.

C. in cutting best to keep the temperature and speed of harmony. If you smoke too much, may be too slow because the cutting blades or the temperature is too high. This may cause irregular cutting path, uneven, this kind of situation, can pass through the lower blades or the temperature in the cutting time intermittently release the switch. When the 3-5CM is cut from the distance, the switch is released.

D. with a wire brush to clean the blade.

Matters needing attention:

A. please be sure to use this tool in the ventilation environment.

B. do not burn residual debris on the blade or blades will bend.

C. do not dry the blade, please contact the cutting material after heating.

D. do not contact the blade, do not place the hot blade on the clothes, or flammable material next to the.

E. please cool the blade in the blade, so as not to cause accidental injury to the.

F. please do not make the blade burn red without cutting the material.

Maintenance:

Long time use of the KD-5-0 knife can lead to the deposition of the cutting material on the blade, which will affect the performance of the blade and the blade holder. Use wire brush to thoroughly remove residues. When not in use, it is recommended to apply ordinary oil on the edge of the blade to prevent rust.

[xlmodel]-[photo]-[0000]

Photos List

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

aeProduct.getSubject()

[xlmodel]-[products]-[8888]

You Will Like ...